Hi, I'm an old German, living in Paraguay with a T30 2366 2GHz, 1GB, 1400x1050
display, 60GB HDD (hitachi) 7200RPM..., WinXPprof SP3,
I'm new here and have since 3 days many trouble with the the above errors.
Also I found, that the UUID is set to all ffff...
It just happened in the morning at the first boot without havving any
trouble before and without any tinkering with HW nor SW the days before
I don't know, what's with these error, IBM only tells, to change the Motherboard
It didn't boot and hangs with the above error message 0189 Invalid RFID...
I couldn't find any good explanation for that failure und searched a lot
of places.
I don't know, what's with these error, IBM only tells, to change the Motherboard
I found a way, just to go ahead from an other place:
change BIOS boot mode to Diagnostic:![Patch Fix Keyboard Rfid Patch Fix Keyboard Rfid](x-raw-image:///e71fe1960d744724d6d8acd0d0d763f1b5314c456ed319d3ba71077536d9a5ea)
--Startup
---Boot Mode [Diagnostic]
and boot again, wait for the error 0189... and hit <ESC>
So with the memory test it runs quite a while, but then it boots normal
to the WinXP.
While boring with the long RAM test, especially with my 1GB, I managed to
hit the <SPACE> Bar. BINGO the RAM test is terminated immediately and the boot![Patch Patch](/uploads/1/2/6/4/126472054/723189029.jpg)
goes on and shows the 0189 error, than <ESC> ist much faster, however I'm
not extremly lucky with that.
End of Part 1
Get exclusive access to gated site content by becoming an Insider! FREE Membership unlocks hundreds of Insider articles, guides, reviews, interviews, blogs, and other premium content from the best.
display, 60GB HDD (hitachi) 7200RPM..., WinXPprof SP3,
I'm new here and have since 3 days many trouble with the the above errors.
Also I found, that the UUID is set to all ffff...
It just happened in the morning at the first boot without havving any
trouble before and without any tinkering with HW nor SW the days before
I don't know, what's with these error, IBM only tells, to change the Motherboard
It didn't boot and hangs with the above error message 0189 Invalid RFID...
I couldn't find any good explanation for that failure und searched a lot
of places.
I don't know, what's with these error, IBM only tells, to change the Motherboard
I found a way, just to go ahead from an other place:
change BIOS boot mode to Diagnostic:
--Startup
---Boot Mode [Diagnostic]
and boot again, wait for the error 0189... and hit <ESC>
So with the memory test it runs quite a while, but then it boots normal
to the WinXP.
While boring with the long RAM test, especially with my 1GB, I managed to
hit the <SPACE> Bar. BINGO the RAM test is terminated immediately and the boot
![Patch Patch](/uploads/1/2/6/4/126472054/723189029.jpg)
goes on and shows the 0189 error, than <ESC> ist much faster, however I'm
not extremly lucky with that.
End of Part 1